1998 Ford Windstar Strut and Spring Assembly REMOVAL AND INSTALLATION
download Removal 1. Raise the vehicle on a hoist. 2. Remove the front wheel and tire assembly. 3. CAUTION: To avoid damage to the 6mm drive hole in the front stabilizer bar link ball stud, do not use...
View Article2001 Ford F-Super Duty 250-550 Wheel Hub REMOVAL AND INSTALLATION
download Removal All vehicles 1. Remove the wheel and tire assembly. For additional information, refer to Section 204-04. 2. NOTE: Caliper is removed for clarity. Position aside the front disc brake...
View Article1994 Ford Explorer SPINDLE & SHAFT ASSEMBLY Removal Installation
download Removal 1. Raise and support vehicle. Remove wheel assembly. Remove caliper from rotor. Remove locking hub. See AUTOMATIC LOCKING HUBS or MANUAL LOCKING HUBS under REMOVAL & INSTALLATION....
View Article2003 Toyota Avalon Floor Shift Assembly REMOVAL
download 1. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY 2. REMOVE FRONT ASH RECEPTACLE ASSEMBLY 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 4. REMOVE CONSOLE BOX PLATE 5. REMOVE REAR CONSOLE BOX...
View Article2000 Ford F-Super Duty 250-550 Hub Removal
download 1. Set the parking brake. 2. Loosen the retaining bolts. 3. Raise the vehicle to the desired working height, keeping the axle parallel with the floor; for additional information, refer to...
View Article2004 Ford F-Super Duty 250-550 Wheel Hub Removal
download 1. Remove the wheel and tire assembly. For additional information, refer to Section 204-04. 2. NOTE: Caliper is removed for clarity. Position aside the front disc brake caliper and anchor...
View Article1999 Jaguar XJ8 Vanden Plas SUSPENSION DESCRIPTION
download The XJR and XJ8 uses an independent coil spring-type rear suspension. Outer bearing carrier and hub assembly is supported by control arm at bottom, and utilizes axle shaft as upper support....
View Article1997 Ford F-250/350/Super Duty Axle Shaft, Hub, Oil Seal and Outer Wheel...
download Removal NOTE: If, for any reason, the rear hub (1109) is removed from the spindle, the old hub seal must be removed and a new hub seal installed. 1. Set the parking brake and loosen the eight...
View Article2000 Ford Ranger FRONT SUSPENSION – 4WD TORSION BAR HUB & WHEEL BEARINGS...
download CAUTION: DO NOT attempt to repair hub and wheel bearing assembly. Removal CAUTION: DO NOT remove hub lock assembly by prying on hub lock legs. This can crack or break hub locks, causing vacuum...
View ArticleSUZUKI GRAND VITARA 1999-2002 VEHICLE WIRING
WIRING INFORMATION 1999 Suzuki Grand Vitara WIRE WIRE COLOR LOCATION 12V CONSTANT WIRE WHITE/GREEN Ignition Harness 12V IGNITION WIRE BLACK/BLUE Ignition Harness SECOND IGNITION WIRE BLUE/BLACK...
View Article
More Pages to Explore .....